Updating kitchen cabinets with molding explain carbon 14 dating procedure

It is soft on the inside and I wanted it to be as smooth as possible.Again, caulk if you want, but the primer and paint did a great job of hiding it for me.This kitchen remodel has been my biggest undertaking yet, and definitely the most fun!

I did take my detail sander and sand the edges of the plywood again in any spots where it looked a little rough.My doors have a slightly rounded edge, so I measured right were the rounding started, this does leave a small lip on the outside of all my trim.When you have your pieces cut you will notice that the inside of the plywood isn’t solid wood.Be sure to wipe it clean and so that there is no dust left on the doors.Once they are all sanded it’s time to work on the trim (plywood strips).I took all my pieces, stood them on their sides and sanded that part down as much as I could with the 220 grit sandpaper.It won’t be perfect, but when you apply the primer and paint, it will fill that in petty well. Fill in all the spaces between the trim pieces and the nail holes in the trim.I measured all my doors and decided on going with a trim width of 2.5″ and I’m very happy with that size.So once you have this done you will leave with lots of 8′ strips of plywood.Measure each of your doors individually before cutting your trim to the size of your door.I like to go with the whole measure twice cut once theory!

Leave a Reply